Replacing your Personal Identifier power cell...               

Identity/Sekurit's power cell can be purchased at most electronic stores, i.e. Longs, Radio Shack, Walmart. The battery is a type CR2032

or a CR2450 lithium cell. Check your Owners manual for exact battery type, or open the unit and the number will be on the battery.

Batteries vary, depending upon models.

The power cell in your Identity/Sekurit "Personal Identifier" will need replacing about every 9-12 months with the CR2032 and about 2 years for the CR2450..

The LED on the front of your "Personal Identifier" will  flash when the button is pressed. If you normally have your identifier set to "motion transmit mode, it will change to manual mode to give you a heads up. When this occurs, you have about 50 starts to change the battery.

To replace your power cell, just remove the two Phillips screws on the back of your "Personal Identifier",

and remove the battery by pushing it out with the screwdriver. Before you exchange the Lithium power cells and screw the case back together be sure to bend down the two tension tabs located at the top of the battery housing. (Be sure to place the battery in the "Personal Identifier" with the same side face up) That's it!

To order a replacement Identifier click here

Replacing your "Wireless Pin Device" power cell...

The power cell in your "Wireless Pin Device" will need replacing about every 2-3 years, depending upon use.

The battery type is a CR1225.This battery can also be purchased at any Long, Radio Shack or Walmart as well.

This unit requires 2 batteries.

To Replace the power cell, just remove the two phillips screws on the back of your Wireless Pin Device, exchange the Lithium power

cells the same way that they were removed, and screw the case back together. Both batteries will be opposite of each other.

(If after changing the batteries, if the LED does not light when the send button is pushed, reopen the device and turn the batteries over.