Identity Owner's Manual

 Identity Personal Identifier replacement click here

Changing Modes

Programming from manual mode to automatic mode

1.Place your thumb on the Identity label and press down to make the red light turn on.

2.Hold down until the light goes out.

3.Press three times rapidly.

4.The light will flash five times to let you know the Personal Identifier (PI) is in motion transmit mode.

Manual mode requires the user to press the label. Once pressed, the vehicle may be started for the next 30 seconds. The battery will also last longer.

Programming from “motion activated” to manual mode

1.Place your thumb on the Identity label and press down to make the red light turn on.

2.hold down until the light goes out.

3.Press three times rapidly.

4.The light will flash three times to let you know the Personal Identifier is in manual mode.

Note: Newer Identity identifiers require you to press three times again once the identifier blinks back the three or five times and then flickers to confirm the change in mode.

Identity Product Information

Helpful Information

*The battery life may last from 9 months to as much as 2 years.
*The Personal Identifier conserves battery life when in “Manual Mode”.
*One Personal Identifier can be programmed to many different vehicles for multi-users.
*Each Identity system can be programmed with up to 6 Personal Identifiers per vehicle.
*Each Personal Identifier has its own completely unique digital code. (like a fingerprint).
*If your vehicle’s battery goes dead, it will not effect your Identity system.
*To test the Identity system, take the Personal Identifier (PI) off your key chain or from your
purse and set in on the dash. Wait thirty seconds and try to start the vehicle. The vehicle will not start! Pick up the PI and the vehicle will now start. *Any component we removed to perform the install is placed in your vehicle’s glove box.

 

Important! Never be stranded

One day you will try to start your vehicle and it will not start, don’t panic. Press the label on your Personal Identifier and then start your vehicle. When your battery gets low, the system switches from “Motion Activated” to “Manual Mode”. If you press the label and the light alternates between red and green, you must change the battery immediately!

The location of your Identity Computerized Control Circuit ( CCC )

The CCC is under the hood in the power distribution box or inside the vehicle, under
the dash on the driver’s side. When we install Identity, your original removed component is
placed in the glove box. In the event of a broken or lost Personal Identifier, this may replace the
CCC to get you started. Hide it in the vehicle.

Battery Replacement

Remove the 2 phillips head screws from the back of the transmitter and slide out the old battery. Push down on the 2 battery holder arms to ensure non movement once the new battery is positioned.

The battery used in the Personal Identifier is a CR2450 Lithium cell. It may be purchased at many stores. Radio Shack, Longs Drug and Walmart.

For more information contact: Dealer Security Solutions Mon-Fri. 9-3 PST

1-916-851-9073 Phone  or toll free 1-888-NO THEFT (668-4338)